Warm sewing studio worktable with folded fabrics and dressmaking tools

Thread tension is the balance between upper and bobbin threads as they form each stitch. When the balance is appropriate for the fabric, the threads interlock within the layers rather than leaving loose loops on either side. Because machine designs vary, a number printed on a tension dial is not a universal setting.

Start with a good test sample

Cut two layers of the actual project fabric, ideally with the same interfacing or lining combination you will sew. Use the correct needle, suitable thread, and a stitch type appropriate for the material. Sew a line, then examine both sides without pulling the seam.

A neat line of straight stitches should look relatively even. Some delicate fabrics can pucker because of needle size, thread weight or the feeding process even when the nominal tension looks balanced.

Troubleshoot in the right order

  1. Rethread the upper path. Raise the presser foot while threading so the thread can sit between the tension discs. Check the take-up lever and needle-bar guides.
  2. Check the bobbin. Confirm that it is the correct type, wound evenly and placed in the correct direction. Make sure thread passes under the proper bobbin tension spring if your model uses one.
  3. Replace a suspect needle. A worn, blunt, bent or wrong-type needle can cause skipped stitches and thread damage that resemble tension trouble.
  4. Test the stitch on scrap. Only after those checks should you change the upper tension, following your machine manual. Make one small change at a time and record which direction helped.

What the symptoms may mean

Large loops underneath: Frequently indicates an upper thread that has missed a guide or the tension mechanism, although other threading errors are possible. Upper thread visibly lying on the underside: May mean the upper tension is too low relative to the lower thread. Fabric puckering: Could indicate too much tension, a needle-thread mismatch or fabric being stretched as it feeds. Thread breaking: Inspect for wrong needle size, rough surfaces, tangles or overly tight tension.

Avoid adjusting a bobbin-case tension screw unless your machine manual directs you to do so. That adjustment can make later troubleshooting more confusing.

Keep a small settings record

Once a sample works, record fabric type, needle, thread, stitch length and tension setting. A second sample after pressing can reveal whether the seam lies flat in the finished garment.

Brother’s manufacturer support notes that incorrect threading, excessive tension and tangling can contribute to fabric puckering: Brother: fabric feeding and puckering.

Next, visit machine threading basics or practice a steady straight seam.


Ready for another project?

Explore our project finder to match sewing ideas with your experience.

Browse project guides