Sewing tools, thread and scissors arranged on a worktable

A missing button is one of the simplest clothing repairs, but a rushed replacement can pop off again after a few wears. The goal is to anchor the button securely without pulling it flat against thick fabric. Most shirt buttons have two or four holes; coat buttons and decorative shank buttons need slightly different treatment.

Match the button to the garment

Use the original button if possible. If it is missing, compare diameter and thickness with the other buttons on the garment. A replacement that is much thicker than the original may not fit through the buttonhole; a much smaller one may slip out.

You will need a hand needle, suitable thread, small scissors and the button. For heavier coats, select stronger thread and a sturdy needle. To find the correct position, button the garment using nearby buttons and mark where the missing button should sit; do not guess from a distorted fabric edge.

Stitch a flat button

  1. Thread your needle and knot the end. Starting from the wrong side, make two small anchoring stitches where the button will sit.
  2. Bring the needle through one button hole, then down through the opposite hole and the fabric. If working with a four-hole button, sew the first pair several times before stitching the second pair.
  3. Keep a little space between the button and the fabric. A toothpick or matchstick laid temporarily across the button face can help maintain a small gap; remove it before finishing. This space forms a short thread shank so the fabric under the button can fit comfortably.
  4. Bring the needle up beneath the button without passing through a hole. Wrap the thread around the stitches between button and fabric a few times to form a compact shank.
  5. Pass the needle to the wrong side and take several small securing stitches. Knot the thread, then trim the end without cutting too close.

Check the fit

Fasten the button through its buttonhole. The closure should lie flat without pulling or gaping. If the button feels too tight against the fabric, recreate the thread shank with a little more clearance. If you can see the thread anchor pulling through delicate fabric, reinforce the area from behind with a small, discreet backing patch.

What about shank buttons?

A shank button already has a loop behind it. Sew through the loop, not through holes in the face. For heavy outerwear, a small backing button on the inside can distribute strain if it suits the garment’s construction.

A few minutes spent on a reliable repair can prevent a larger tear around the fastening. Continue with our hand-hemming guide or explore the sewing tutorials library.


Ready for another project?

Explore our project finder to match sewing ideas with your experience.

Browse project guides